Specification:
Brand name: ImmersionRC
Item name: Vortex 150 FPV Racer
Wheelbase: 155mm
Arms: 2mm Flat CF/Plastic Hybrid
Frame: 2mm CF, with Aluminium Standoffs
Motors: Custom 1306-3100kV, 2mm Shaft
ESC: 16/20A EzESC Gen3
ESCs: Full Custom, 16A cont. 20A peak, rotorSENSE, OneShot125, OneShot42, Multishot
Flight Controller: STM32F303 based ('F3')
Gyro: SPI Gyro, for 8kHz loop speeds
OSD: Full Graphic
Video Tx Power: 600mw 40CH
Receiver Compatibility: CPPM, S-Bus, Spektrum™, XBus, SumH, SumD (no external adapters required) (Auto-Sense!)

FPV Camera: FatShark 600TVL CCD (HS1177 sensor + chipset)
Flight Time: Highly dependent upon battery, and flying style, 3-4 mins typical
Power Requirements: 3s-4s LiPo, 4s 750mAh >45C recommended
Weight: <249.99g w/500mAh pack
Note: Compatible receiver and display device required for initial setup and use, not included.

Feature:

Twin ‘F3’ Processors (Flight Control, and OSD)
3rd Gen 16A EzESCs, With OneShot125/42, and MultiShot support
Fusion of 3k weave Carbon Fibre and molded, tough plastic
Direct connection to PPM, Spektrum, S-Bus, XBus receivers
 4s 500mAh – 750mAh battery recommended

Package Included:
1 X Vortex 150 Frame
4 X ESC
4 X Motor
4 X 3″ Tri-Blades
1 X 5.8G 40CH TX Module
1 X FPV Camera

Comments

Popular posts from this blog